WhoLib *IN*compatibility

Found a bug with the CensusPlus UI Mod? Post it here!
Post Reply
User avatar
FuxieDK
Census Taker
Posts: 659
Joined: Thu May 22, 2008 11:36 am
Location: Copenhagen, DK

WhoLib *IN*compatibility

Post by FuxieDK »

Yesterday, I installed SpamMeNot.. This AddOn uses WhoLib, which means that it will make CensusPlus do the same..

I logged on, started CP and saw the message "Using WhoLib" in the chat-window.. The scan seemed to run fine, except for some rather big numbers of online players, but nothing impossible (at that point).
However, when I saw that first 41-50 search, then 46-50 and 49-50 searches all resulted in 50 players found, I was confirmed in my belief that something was wrong..

When CP did the level 49 searches, there was still 50 found, Bloodelf search, STILL 50.. Warlock, still 50..
Even Level 49, Bloodelf Warlock "single letter search" yielded 50 results each..

This continued all the way down to level 46, where I stopped the scan..

Some might say, well there could so many online.. NO! I checked the interface-window and only 4 level 49 players had been scanned total (3 before this incident)..
Anyway, I logged out, disabled SpamMeNot, logged back in, did a Census (no WhoLib) and all went fine (still only 4 level 49, so doubtfull that revelal hundred level 49 Bloodelf Warlocks log out at the same time)..
Logged out again, enabled SpamMeNot again, and the same happened again.. At level 49, it went crazy.. :-(

I'm using latest CP and SpamMeNot was straight from Curse..

User avatar
Rollie
Site Admin
Posts: 4783
Joined: Sun Nov 28, 2004 11:52 am
Location: Austin, TX
Contact:

Post by Rollie »

Hrm... definitely something not working well together =/
phpbb:phpinfo()

User avatar
FuxieDK
Census Taker
Posts: 659
Joined: Thu May 22, 2008 11:36 am
Location: Copenhagen, DK

Post by FuxieDK »

Another matter I noticed, while testing WhoLib, is that normally when I start a census, I always do a /who <guildname> (my own guild) and /who <playername> when someone I know (or myself) ding.

However these manual /who seem not to be caught by CP like they are, when WhoLib isn't used.. I know this is probably due to the nature of WhoLib, but can something be done about it?
Doing census mainly on Draenor; Raluf - Nimsay - Lusmo - Quixx - Sosyan - Garthog - Trubin - Zalistra - Zesmi and Djaang

User avatar
FuxieDK
Census Taker
Posts: 659
Joined: Thu May 22, 2008 11:36 am
Location: Copenhagen, DK

Post by FuxieDK »

I've made a Census with and without WhoLib.
File contains both log-window and LUA-file

Please tell me if this helps or not..

At 19:44:56, I paused CP (for 1 minute), but the log continued (as shown).
Also, after scan was aborted, CP still found entries..


The run without WhoLib ran normally from start to end.

User avatar
Rollie
Site Admin
Posts: 4783
Joined: Sun Nov 28, 2004 11:52 am
Location: Austin, TX
Contact:

Post by Rollie »

meh, I'll look into it, thanks for the effort =)
phpbb:phpinfo()

User avatar
FuxieDK
Census Taker
Posts: 659
Joined: Thu May 22, 2008 11:36 am
Location: Copenhagen, DK

Post by FuxieDK »

Any thoughts?
Doing census mainly on Draenor; Raluf - Nimsay - Lusmo - Quixx - Sosyan - Garthog - Trubin - Zalistra - Zesmi and Djaang

User avatar
FuxieDK
Census Taker
Posts: 659
Joined: Thu May 22, 2008 11:36 am
Location: Copenhagen, DK

Post by FuxieDK »

/bump
Doing census mainly on Draenor; Raluf - Nimsay - Lusmo - Quixx - Sosyan - Garthog - Trubin - Zalistra - Zesmi and Djaang

Post Reply